Sp-controls CatLinc Uživatelský manuál stáhnout pdf (Strana 13)

CatLinc HD

The CatLinc HD allows component video (Y/Pb/Pr or YUV) connection

between two devices using CAT5, CAT5e, or CAT6 twisted pair cable.

Connection is made to devices using 3 standard RCA connectors. No con-

figuration is necessary.

The CatLinc HD can extend a component video signal up to 365m/1200ft

over standard CAT5. For shorter distances (110m/350ft or less), system

power may be attached at either the Transmitter or Receiver. For distances

greater than 110m/350ft, the CatLinc Transmitter and Receiver must both

be powered. In this case, an additional power supply must be separately

ordered (part no. CatLinc PS).

INDICATES POWER

IS PRESENT

CatLinc VID/S-VID/HD

TRANSMITTER

INDICATES POWER

IS PRESENT

CatLinc VID/S-VID/HD

RECEIVER

(Figure 5)

(Figure 6)

TROUBLESHOOTING

No Picture:

-All Units: Verify that the unit at the source (VCR, computer, et cetera) is

the Transmitter and the unit at the destination (projector or monitor) is the

Receiver.

- All Units: Verify that your video device is properly sending an active sig-

nal. Note: Most Laptops need to be configured to export an extrenal VGA

signal.

-All Units: Ensure that the power supply is plugged in and that the Power

indicator is lit on both the Transmitter and the Receiver.

-CatLinc VGA/VGA-L: ensure that the Signal LED is lit on both the

Transmitter and the Receiver. If the Signal LED is not lit on the Transmitter,

the laptop may not be exporting the VGA signal. If the Signal LED is not lit

on the receiver, check the cabling.

-CatLinc VID/S-VID/HD: Verify that the connection landings on the

Transmitter agree with the connection landings on the Receiver unit. For

example, for CatLinc HD if the Y signal out on the display device is connect-

ed to the green CatLinc RCA on the Transmitter, the green CatLinc RCA on

the Receiver must be connected to the Y signal input on the display device.

-CatLinc VID/S-VID/HD: in CAT5 runs exceeding 110m/350ft in length, be

sure that both the Transmitter and Receiver units are powered. Additional

power supplies can be ordered from SP Controls (part no. CatLinc PS).

Poor Image Quality:

-All Units: Verify that all components and cables are plugged in securely.

-All Units: Check computer settings for scan rate and refresh rate. Most

LCD/DLP projectors work fine with a scan rate of 60 Hz. Changing to 60Hz

may improve the image. A higher scan rate will not improve image quality of

LCD/DLP projectors.

CatLinc VGA/VGA-L: Ensure that the Detail Adjustment procedure has

been followed (see pg. 3).

For optimal image quality, set the refresh

rate of your video device to 60Hz. Also, check to make sure that the

resolution of your display device matches the resolution of your

video source

1 2 ... 8 9 10 11 12 13 14 15 16 17 18 19 20

Komentáře k této Příručce

Žádné komentáře

Sp-controls CatLinc Uživatelský manuál Strana 13

Komentáře k této Příručce

Související produkty a manuály pro Audio Sp-controls CatLinc